How can you go wrong with knowing the best information available when it comes to plumbing? You have come to the right place if you want to know the most reliable and well proven tips and tricks to use. Take a few minutes and read the advice we provide here in this article.
To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.
You can check your toilet for leaks by adding a few drops of food coloring, Kool Aid or some coffee grounds to the water in the toilet’s tank (not the water in the bowl). Check the water in the bowl after a half hour or so. If any of the coloring agent is visible in the water in the bowl, the tank is leaking, and you will have to have it repaired.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
In conclusion, you know that it is more than significant to obtain reliable and helpful information when it comes to plumbing. Your time is important and so is the work that you do. Go out and use the advice provided here and be assured you are doing the right thing.